Boostdriven
10+ Year Contributor
- 622
- 14
- Jan 7, 2010
-
Pasco,
Washington
Any updates on the set up?
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
This site may earn a commission from merchant
affiliate links, including eBay, Amazon, and others.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Sorry don't have much time to comment on the technical aspects maybe this weekend.
You must be logged in to view this image or video.
This should improve the signal quality of my exh manifold pressure channel on the M800 without electronic signal conditioning! Running 4 taps into a damper chamber with the sensor instead of only one in the collector is a def improvement in data acquisition!
Very clean install. I wouldn't have ever thought to go through the flange like that.
I'd love to see a before and after difference of the data that you gather. Meaning this configuration vs. from a single point on the manifold.
Any results from this setup yet? I'm curious to know if this works better them a single port on the collector of a manifold.
I have mine into the upper bolt hole that used to hold the turbine heat shield. Its right at the opening of the housing. It reads, but not very stable.
I'm going to test this soon. I have an FP3052 w/ 44mm wg, and a header mounted wg that I'll run back to back on the dyno. And just to make 100% sure of the results I have an identical header with no wg provisions.