stall after rev

talondude4 · May 27, 2013

So I been away from dsm's for a while, some of you might remember me. So my car i just pick is a 95 talon tsi. 137k miles, I start it and it runs fine but when you rev or drive and let then engine fall back to a idle it will just die out, after it dies out I restart it and the car will start for a sec and stall out.

steve · May 27, 2013

Does it run if you don't let the throttle close?

When did you check the ISC and BISS last?

smills1840 · May 27, 2013

Check to make sure your MAF is plugged in and clean.

Also, have you had the battery disconnected recently?

talondude4 · May 27, 2013

I bought the car used, it Sat for two months. The battery was dead when i went to start it. Maf is clean well conected and I have not messed with the biss screw or anything yet. Its been a while since I last worked on one. Bov is recirculating now, guess someone liked the pssshhh sound LOL

SNAKE_15 · May 27, 2013

That recirculator tube you put on will probably fix it because I didn't have the hose to recirculate mine and sometimes when Itart my car it idled close to zero and tries to die if I try to drive it

talondude4 · May 27, 2013

steve said:
Does it run if the don't let the throttle close?

When did you check the ISC and BISS last?

Yes it runs, if I keep feathering the throttle around 1k rpm I can get it to idle again.

SNAKE_15 said:
That recirculator tube you put on will probably fix it because I didn't have the hose to recirculate mine and sometimes when Itart my car it idled close to zero and tries to die if I try to drive it

Lol was my thought and it didn't work

milby43 · May 27, 2013

Had a problems like this, I went back and set base timing and idle, Checked all my vacuum lines. The first time it was my IAC.

talondude4 · May 28, 2013

Well I will tinker on it today and try to get some video on it. Maybe some sound will help out more.

smills1840 · May 28, 2013

I had this problem when I had my battery disconnected for about an hour. Apparently the ECU resets and loses its settings for the ISC and other sensors.

I drove it around for about an hour, and the ECU re-learned everything and ran great.

talondude4 · May 30, 2013

Had a hole in the fmic.

got it fixed now and drove the car. It over heats on the interstate but not in town driving? Fmic to big? Any thoughts?

The Top DSM Community on the Web

stall after rev

talondude4

steve

smills1840

talondude4

SNAKE_15

talondude4

milby43

talondude4

smills1840

talondude4

Similar threads

Latest posts

Build Thread Updates

Vendor Updates

Latest Classifieds