The Top DSM Community on the Web

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. Log in to remove most ads.

Please Support ExtremePSI
Please Support STM Tuned

Fluid inside Slave Cylinder Leaked

This site may earn a commission from merchant
affiliate links, including eBay, Amazon, and others.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

squid267

10+ Year Contributor
158
3
Jan 14, 2012
Worcester, Massachusetts
I was working on my engine swap when the piston and dust cap popped off the slave cylinder and fluid inside leaked.

Will refilling clutch fluid reservoir and bleeding the system refill the fluid inside the slave cyclinder? Or should i buy a new one? Current the clutch pedal sticks to the bottom of floor.

Thank
 
Last edited:
I was working on my engine swap when the piston and dust cap popped off the slave cylinder and fluid inside leaked.

Will refilling clutch fluid reservoir and bleeding the system refill the fluid inside the slave cyclinder? Or should i buy a new one? Current the clutch pedal sticks to the bottom of floor.

Thank

classic sign of a bad slave. buy a brand new one and install it then bleed it properly and verify the clutch pedal is no longer mushy or stuck to the floor. they cheap at the auto parts store.
 
bought new one from autozone

You must be logged in to view this image or video.


You must be logged in to view this image or video.


what direction does piston go in. and how do i get it in? do i take off rubber dust cap?
 
A sign of a bad slave? Interesting. I had dust cap and piston fall out while working on my clutch. I just put it back together, and added some fluid and the clutch is still working like a charm and there's no leak at the slave cylinder.

For those that stated this indicates a bad slave would you explain why?
 
if fluid is leaking past the seal inside the bore than you are not getting full pressure to the clutch fork and could run into bigger problems down the line
 
so i got the new installed and and bleed it. worked solid. i havent worked on the clutch in about a week. i hit the clutch today and it stays stuck on the floor. but after i pumped it a few times it worked as normal. did it act up because i havent used it? or i need to bleed again?
 
Support Vendors who Support the DSM Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Innovation Products Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications MyMitsubishiStore.com RixRacing RockAuto RTM Racing STM Tuned

Latest posts

Build Thread Updates

Vendor Updates

Latest Classifieds

Back
Top