The Top DSM Community on the Web

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. Log in to remove most ads.

Please Support STM Tuned
Please Support Morrison Fabrication

AEM EMS G1 - Low Z 1250 injectors. Do I need injector drivers for a nice idle?

This site may earn a commission from merchant
affiliate links, including eBay, Amazon, and others.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

tunermag

15+ Year Contributor
51
8
Apr 12, 2005
Buenos Aires -, South_America
As the topic title says, I have the following setup:

Eclipse 1G stroker
FIC Bluemax 1250 cc (low impedance)
AEM EMS Gen 1

We recently finished the build and we are getting problems to get a good idle. Since the Gen 1 EMS can't only control high Z injectors we left the resistor box in place.
Car is going very rich, even with 500ms injection pulses.

Do I need an Peak & Hold Injector Driver Module like the AEM one and get rid of the resistor box?
Or, can we get a good idle with the current setup?

Tks
 
Did you talk to FIC about the correct battery voltage settings? (I forget what the proper term is off the top of my head). Latency I think, I've been up for 28 hours... LOL

What's the base fuel pressure at? What idle RPM are you trying to hold?
 
Did you talk to FIC about the correct battery voltage settings? (I forget what the proper term is off the top of my head). Latency I think, I've been up for 28 hours... LOL

What's the base fuel pressure at? What idle RPM are you trying to hold?

Tks, I've just write them to ask for the battery offset. I've lost the datasheet.

This was the first start after 3 year project, base fpr 43.5
 
I've got these numbers from FIC tech support

8 Volt 10 Volt 12 Volt 14 Volt 16 Volt
Injector latency (ms) 1.75 1.56 1.35 1.17 0.98

I understand that I need to multiply those per 1000 to get the battery offset number to load in EMS software. Is that right?

So, for 12 volts, 1350 in battery offset is ok?
 
I've got these numbers from FIC tech support

8 Volt 10 Volt 12 Volt 14 Volt 16 Volt
Injector latency (ms) 1.75 1.56 1.35 1.17 0.98

I understand that I need to multiply those per 1000 to get the battery offset number to load in EMS software. Is that right?

So, for 12 volts, 1350 in battery offset is ok?

For a Series I, yes, that's correct. Series I uses uS (microseconds) whereas the data above is in mS (milliseconds). Series II uses mS directly. 1000uS=1mS

Beau
 
For a Series I, yes, that's correct. Series I uses uS (microseconds) whereas the data above is in mS (milliseconds). Series II uses mS directly. 1000uS=1mS

Beau

Tks.

Initial idle tunning improves a lot with those parameters. After working with the cams, timing, etc, the car is ok.
 
Support Vendors who Support the DSM Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Innovation Products Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications MyMitsubishiStore.com RixRacing RockAuto RTM Racing STM Tuned

Latest posts

Build Thread Updates

Vendor Updates

Latest Classifieds

Back
Top