BSE kit install question

cnordelo · Sep 17, 2012

Hello all. I am going to install an oem bse kit to finish up my bottom end. I have seen the videos but i. Not clear on the bearings that are pressed in the block. Do they come out? If removed does it effect oil pressure as far as dropping through journals? Thanks.

TSITurbo95 · Sep 17, 2012

When you knock out the old bearings, you install the new ones with the oil hole towards the side, this blocks the oil from coming out of the oiling hole (up top).

GPLaserRS · Sep 17, 2012

Use this, Balance Shaft Eliminator Kit Install, lots of pics and great step by step directions. Good luck and take your time, double check that you don't miss anything.

Boost25 · Sep 17, 2012

GPLaserRS said:
Use this, Balance Shaft Eliminator Kit Install, lots of pics and great step by step directions. Good luck and take your time, double check that you don't miss anything.

This is great advice. The vfaq is a great source of information.

psx · Sep 17, 2012

Go to autozone and rent a "OEM/Bearing and Race Installer" it makes the bearing removal and install in under 20 minutes.

And_44 · Sep 17, 2012

I'd prefer the method of removal and install that mentioned in the Vfaq. Those kits from the autoparts store have a tendacy ruin parts. Sharp edges and such can gouge parts. If you use one buy new so it's meant to the way it was built.

The Top DSM Community on the Web

BSE kit install question

cnordelo

TSITurbo95

GPLaserRS

Boost25

psx

And_44

Similar threads

Latest posts

Build Thread Updates

Vendor Updates

Latest Classifieds