New gasket for compressor cover on 14b doesnt fit?

Rengar18 · Jul 18, 2012

You must be logged in to view this image or video.

So just ordered a td05 rebuild kit from tradergreg to rebuild my 14b.

Rebuild went smooth except when i put the circler red gasket on the center housing and put the compressor cover on it, it doesnt seat right and i can spin the compressor cover.

Im sure with it spinning like that its not sealing right and im going to have a huge boost leak. Any particular reason why it wont hold? Even with the snap ring on it still spins.

JusMX141 · Jul 18, 2012

You shouldn't be able to spin the cover at all. Sounds to me like you're not lining up the locating pin.

You must be logged in to view this image or video.

TSITurbo95 · Jul 18, 2012

^ What Justin said. But I have also gotton covers that are missing that pin. In that case, you'll have to line up the holes where that "pin" should be. It's easier to lube up the seal first before putting on the compressor cover. Either use some spit, PJ, assembly lube, etc on the seal then press it on, it will go on like butter.

jjrock5 · Jul 18, 2012

Lube on the o-ring is key for me as well.

Rengar18 · Jul 18, 2012

Got it, the lube did the trick. I had it on the pin but it wouldnt actually SEAT for shit. I even took a mallet and tried to hammer it down and it wouldnt seat. Of course some lube and pressing it down did the trick. Thanks for replying quickly fellas.

TSITurbo95 · Jul 18, 2012

No problem.

The Top DSM Community on the Web

New gasket for compressor cover on 14b doesnt fit?

Rengar18

JusMX141

TSITurbo95

jjrock5

Rengar18

TSITurbo95

Similar threads

Latest posts

Build Thread Updates

Vendor Updates

Latest Classifieds