drive pully removal

Nate_Hustle · Oct 15, 2011

what is this gear?- it goes into my timing belt and seems to want to come out when i remove the main drive pully- is this supposed to occur? its seems to be attached somewhere. i have pulled the main bolt and the four front bolts holding the pully onto the front of the motor. the pully just wont pull off without pulling this gear out. am i doing something wrong? am i missing something?

fourgsixthree33 · Oct 15, 2011

That is your crankshaft sprocket. You only want to pull the 4 small bolts off the pulley and not the big center bolt. Put the big bolt back in and tighten it up. Then your pulley will come off without the crankshaft sprocket.

What are you taking this stuff off for? Replacing the timing belt or what? Here is some good info Timing Belt VFAQ

Nate_Hustle · Oct 15, 2011

replacing the waterpump- and alternator- thanks for your help

fourgsixthree33 · Oct 15, 2011

You should DEFINITELY replace the timing belt if you haven't recently. You are right there and I would hate to see you not replace it.

Nate_Hustle · Oct 15, 2011

am i pulling the pully off? the remover i have seems to be pulling it off unevenly and b4 I wreck stuff... is this right? it seems to be pulling it off on the right side of the picture frst. im probly just a nervous nelly but i dont want to wreck my baby!

fourgsixthree33 · Oct 15, 2011

She should pull right off. Most of the time you will have to pry it off a little or hit it a few times with a rubber mallet. But shouldn't be too hard. Try to use a prybar behind it. Or use a rubber mallet. You will be fine. You won't hurt anything.

Nate_Hustle · Oct 15, 2011

only the outer ring is coming off- how does the center of the pully come off if the outer ring comes off with the puller?

fourgsixthree33 · Oct 15, 2011

snap another pic quick.

Nate_Hustle · Oct 15, 2011

you have to take the center bolt off to take the pully off. i broke the pulling doing what you said. theres a spring pin that was holding it on after i took the center bolt out. with the bolt out it took me 30 sec to get off. thanks for the advice.

jdigitty · Oct 15, 2011

You don't have to take the center bolt out. If you but a puller on it and only the outer part of the pulley started coming off your going to have to get a new one. try tapping on it to free up.

The Top DSM Community on the Web

drive pully removal

Nate_Hustle

Attachments

fourgsixthree33

Nate_Hustle

fourgsixthree33

Nate_Hustle

Attachments

fourgsixthree33

Nate_Hustle

fourgsixthree33

Nate_Hustle

jdigitty

Similar threads

Latest posts

Build Thread Updates

Vendor Updates

Latest Classifieds