Boom goes the correct dynamite...


Turbine Housing Inlet Gasket (DSM) - Modern Automotive Performance

I apologize again for the misinformation in the first reply.

ha thanks guys i appreciate it. but are you sure the ones from extreme psi will fit? it doesnt look like it will bolt up right. looks to square ish

You wanted a 7CM gasket and there it is.....................

By the way I use that gasket on my evo16g FWIW

Turbocharger Install Components - Slowboy Racing Inc. - The performance experts for factory turbocharged vehicles. here or you can try this one

I got this gasket with my new exhaust manifold. It's going to a stock turbo housing. (6-bolt motor fyi) and I believe I have a turbo leak there. I'm not sure if the housing's deck is good and smooth, that might be why. I boost leak tested the pre-engine side and it's fine. No leakdowns. Just giving a little heads up I'm not sure how I'm going to fix it, but you might want to get some copper spray and clean up the housing deck a little before using. My downfall haha. But yeah these gaskets look a little square, but they do fit, and also if you have that stock ring that sits inbetween the Manifold/turbohousing and helps fitment/leaking you'll have to take it out, as I couldn't get it to slide in.

well i got the gasket from extremepsi, and that one got destroyed. i believe i heard someone talking about titanium ones. anyone know where to get them, or if they even exist

You can get the gasket that your looking for from Mitsubishi Turbo Performance Parts from Mach V Motorsports. Click on oem/maintenance than click on gaskets.

yeaa i dont see any there

Wherever you get it, I would highly recommend the OEM multilayer gasket over the solid stainless steel one that many places sell. I (along with many other people) have had the SS gaskets destroy themselves, but have never had a problem with the OEM MLS gaskets.

BTW - I get mine from Forced Performance

Sorry I left out one step. Go to OEM/Maintenance, then click on OEM Engine, then CLICK on Gaskets.