Replacing H.G.

SwiftKidGSX · Oct 4, 2004

Sup fellas! I will be replacing my head gasket very soon.

I noticed there isnt a tech article on how to do this so I am asking you guys for some tech tips and advice for the fastest and most simple way to go about this. I will have a whole documentation on this from start to finish with pics. Unless someone here has seen or knows where I can find a how to article.

Thanks,
Joey.

WikedSicc · Oct 4, 2004

Turn crank to TDC, tension timing belt, pull vavle cover, unscrew headstud nuts, lift off head. This does not belong in extreme tech. :thumbdown

FireyIce01 · Oct 4, 2004

WikedSicc said:
Turn crank to TDC, tension timing belt, pull vavle cover, unscrew headstud nuts, lift off head. This does not belong in extreme tech. :thumbdown

Agree that this isn't extreme tech, however, I think what he was offering was to make a full write up & wanted tips on easiest way.

I would say get the haynes manual and follew the steps... it's not hard to do.

evotuner · Oct 4, 2004

http://www.dsmtuners.com/forums/showthread.php?t=99037&highlight=head+remove

Advanced search is your friend! :thumb:

sjgYFZ200 · Oct 27, 2004

hey man, i just did it on my 91, and i followed the hynes manual. i have always used hynes, but after doing this i think there junk. it didnt go into detail, didnt have important pictures....put it this way, next time, i wont be openining my hynes for info. good luck tho whatever you use...

Turbonium · Oct 27, 2004

make sure u take the head to a machine shop and get it checked!!! this is very important on our aluminum head, i've done a headgasket only to redo it 1k later so make sure u take it to a m. shop. felpro is good too!
Ryan

IMMORTALSPYDER · Oct 27, 2004

Haynes are only good for the torque specs :cool:

The Top DSM Community on the Web

Replacing H.G.

SwiftKidGSX

WikedSicc

FireyIce01

evotuner

sjgYFZ200

Turbonium

IMMORTALSPYDER

Similar threads

Latest posts

Build Thread Updates

Vendor Updates

Latest Classifieds