Hello everyone. This engine is out of my 1997 eclipse GST. Long story short, I spun a rod bearing in it due to the crankshaft being out of tolerance. I had a block ready to go, so I just swapped them. This engine has never been bored, nor has the crankshaft ever been cut. Bores look great. Upon...
I had an extra one so I threw it in just to see if it would help. I will be deleting the one in the trunk. I have been extremely busy, but this weekend I should be able to mess with it. I'm still having issues and I may try to move the pump in the engine bay.
It is within 2 feet of the nozzle. When I added this one it did not change the amount of smoke. I am going to be trying the check valve closer to the nozzle first.
So I am running 28lbs of boost on a precision pt5858 mitsu back housing. If I kick the meth in sooner it still doesn't help with the fact of the lean spot and smoke on let off. I've tried it before with no success. Link is pulling about 12 percent fuel when spraying meth. And to answer how I...
Hello everyone! So I have been fighting an issue with my snow performance kit for awhile now. First and foremost, allow me to describe how I have the kit installed. I have my tank installed in my trunk. The pump is mounted opposite side of the trunk and a few inches below the tank. Right before...
Replace the gears with what? They are discontinued and finding these transmissions are quite hard. Yes I do know what caused it. This transmission was from a donor car and they literally beat this thing. The intermediate gear was torn up, center differential was blown, and a bunch of debris in...
Hello guys! I have a 1997 gsx. I attached a picture of my 5th gear and 5th intermediate gear. As you can see they are slightly damaged. Can this be fixed? What are my options here? Thank you!