Hi, a few days ago I noticed that my car started to push coolant into the overflow reservoir, so I did some tests and heres what I found:No oil in coolant
No coolant in oil
Compression is perfect
Cant see any smoke when drivingOnly seems like it's pushing coolant under boost, also...
Checked for boost leaks today and found a leak on my Throttle Body which i already knew i had, but i never had issues with that before FMIC and now i do? Dont understand.
Just installed my FMIC(SBR Race Core) with an HKS SSQV Recirc, using a 2g Maf. Well everything seemed fine until i went up on the interstate and everytime i step on it enough to start boosting and let go off the gas, the car bucks like fuel cut. I'm quite clueless as to what it could be as it...
I had something similar on my car, knocking until clutch is pressed in. Well since i replaced my clutch with an ACT 2100, the knock went away completely. I used a used 2100 Pressure plate my friend sold me, new street disk, new ACT TOB, new retaining clip and new clutch fork and pivot. Maybe...
Hey there, after i installed front control arm and sway bar bushings my car's been understeering too much, so Ive decided to buy a rear sway bar along with rear suspension bushings. So I have 2 choices Suspension Techniques sway bar or RM sway bar, which in your opinion is better? After some...
I bought a used ACT flywheel off my friend that had the 6 bolts in it and 3 pins for the presure plate, but when i sent it to a machine shop to get resurfaced, they misplaced the 3 pins. Would stock pins also work? Or do I have to look for the right pins for the ACT flywheel? Any help and input...
I did a leak test and found a leak at my TB shaft seals, but I would have to buy a used TB in order to fix that because no one sells the seals. On another note I'm running only 35 psi of fuel pressure to help lean my car out a little because it runs way too rich and I stink at tuning AFC's...
Hi, if I just start cruising on the streets at about 2K RPM, my car starts bogging unless I give it more gas. And today I took the car out and punched it, 1st gear felt very weak and in 3rd gear at about 5k RPM car starts bogging. Right now I have at small boost leak on my TB shaft seals and...
Hey guys, yesterday I ripped my stock intake manifold off and I need to clean it up because it's all dirty. Well today I'm gonna take it to work and sandblast it. Is there any special coating to preserve the sandblasting look? Or what should I do?
Since I changed my UICP and cleaned my TB, my car has been running very bad. After I installed the UICP I tried the car on my street and it wasn't boosting at all, but later I found out that my MAF was disconnected. I haven't been driving the car and now it seems like I have another problem...