as title states, rear differential out of my 2G. Non LSD manual with no issues. Axles came out of the outer hubs with no issues. Best way to get ahold of me is text.$400 plus shipping330-eight hundred-8737
Several DSM engines for sale. No Shipping on these but may be willing to meet along East Coast1. 7 bolt split thrust X code engine. Very low miles, BSE kit installed. Excellent long block. $8002. 7 bolt short blocks. One is a 97 engine code so it may or may not be split thrust. Need to...
Got an odd one here and after doing some digging I figured I would put this out to the group.While working on a 97 Talon I noticed the inside of the front bumper cover is signed and dated with another number 107I believe this was done on the assembly line since it was dated November of 97...
Been doing some research lately and had a thought that I couldn't find any trial/error on. Methanol Injection has proven itself to be a simple powerful system and had a lot of speculation with using water as a fuel. How many years all of us fought to keep water out of our engines!!Anywho, my...
Good news: it can be fixed.
Bad news: you need different tools.Only way I can think of at this point is to finish it off with a carbide end mill and put the block right into a milling machine. Will take about half hour and you'll have a nice clean hole to work with.Problem your at now is...
Right now you have an empty profile with vague questions and back ground. Post some pics it helps a lot.Give us something to work off of.How do you figure the turbo and starter are shot?
Message our number?Ok guys this is hilarious, who posted this? You got me, I'm laughing, Jus is is you? Hector?It's gotta be one of those dang Suburu guys. Took a picture of his sister and made a fake profile. Or worse yet, the Honda forum!!!Going back to putting Talon together. Thanks...
I have spoken with some guys up in Canada who swear by a hogged out 14B over a 16G housing. They say even after the porting the 14 has more meat left than the 16. One trick is to fill the housing with a light oil like even olive oil, then dump it out and measure until you get the desired volume...
Ok that makes sense.I tried it both ways and was able to calibrate the sensor with the same result. The only difference with my theoretical wiring is that the light does not stay on all the time.So I think both work fine, I just wired it a little different so that the light only comes on...
Ok so found the problem there was a bad ground. Easy fix. Now I have another question.The BLACK calibration wire from the controller is supposed to split, one will go to the push button and the other to the LED then both will ground.The problem is this will bypass the switch because the LED...