I'm trying to see if they will fit my Mirage in the rear, have FWD but they are too short. I can order the awd lower tube from Megan direct if it will work, Thanks!
If you're going to use a solid or even layered copper gasket use copper sealant on both sides, this will cure you. Otherwise use the Felpro composite gasket. Also be sure to use a flat file on the flange before re-installing to check flatness.
The Halman boost controller has a bleeder port. How does swapping the ported fitting out for a AN adapter affect operation? Is the factory bleeder port even needed?
This^I wouldn't recommend An lines as there will only be about 1" of hose as the fittings are so large that the alignment would have to be perfect for it to work right. But it all depends on your setup.