I am 48years old. I bought my car 11 years ago off a guy that had it striped it down to the ground. Many truckloads of parts. It was so bad that the guy couldn't figure out how to get the cv's out so he cut them with a torch. I just wanted the car to look good until I found this site. now I...

perfect thanks

ive serched high and low and cant find the tourqe specs for arp bolts on the mains and con rods for a 2g. please help

the middle pin on your transistor is what controls your tack. my pin backed out and my tack did the same thing

I agree. You have pin point where the air is coming out. pull the turbo out if u have to. Plug the the presure side and go from there.

i put a jdm in my 95. 5/8in has to be cut off the half shaft. need jdm starter. all motor mounts are 1/2in out. need to take out the valve body and change the wiring to have the proper plugs. other than that mine was fine.

I had to cut my front control arm bolts. so i just replaced the with grade 8 bolts of the same size.

I have the same problem. 3" down pipe 16g is what i have. those two things are the problem. I ported my turbo and hopefully fixes it. if it dosen"t i will put an external wast-gate on it.

My light was on when i got my car together. Got ged up with trying to fix it so I just pulled the bulb out of the dash. most people want to get rid of abs antways

take out the gear again and use a marker or somthing that will rub off if it turns so you will know if the gear is turning. when you do this drive slow enough so the speedo wont work.

I have seen them on ebay. Find out why this is happening before you waste any more money. did you take the back plate off?

Whenever I do a leak test I set my pressure regulator at the highest psi that the boost will be and have a quick coupler on the leak tester, so if there is a leak i have more time to find it. and if it is going threw the valves you will hear air coming out the exhaust or valve cover.

for the 5 min it takes, to pull it out. pull the back cover off and check the gear for burrs and for play. It is made of plastic so it wont take much to damage it. If everything is fine might want to check for broken wires.

I have a 95 so i don't know if they are the same but on your power translator, the middle wire is your tach wire. Mine backed out and caused my tach to stop working. Like I say, I have a 2g. I don't know about a 1g

If someone screws you on the classifieds let everyone know there name. XXXX screwed me and someone else. he give us two different addresses. If we nail them on small scams they wont have a chance to screw someones on a big scam.