For the life of me, I can not get this holset to stop leaking between the center section and my @MorrisonFab fitting (which is beautiful by the way! Highly recommend).I have put a new gasket, leaked. Put small amount of RTV on each side of new gasket, leaked.I am at a loss, I know this has...

@Gunner Smith Looks like your map sensor on the left and your MAF connector on the right. MAP uses a vaccum/boost source from the intake manifold. Either use an existing port or drill and tap one. For the MAF you use two of the wires from that harness and connect them to your IAT sensor pigtail...

Thank you, ordered a pig tail to fix it.

For a 2G (4G63),I will be using an AEM water Temp gauge in the 1/8 NPT hole in lieu of the dummy sensor in cluster.The ECU water senor wires broke off extremely close to the sensor and I am unable to repair them. Can I use the 5v wire from the AEM gauge, connect it to the ECU pin, and...

Eliminator, overkill for sure; however, I could not pass up the deal the got.. $150.00.@ec17pse - The purpose for the car as it sits now is just street driven and test and tune at the local drag strip.@jakelandry - The reason I did not go with an in tank is due to running the Vamos fuel...

Are you able to post a photo of the fan wiring? Might be able to help a little more if we can see.

Looking for anyone that has had any experience with the Areomotive Eliminator fuel pump.I will be running the Vamos 2g fuel cell with two -10 an fittings running to a -12 Y.12 Y / -12 line / pre filter / pump / post filter / -10 line to the rail.My question is what size return would be...

Yes, I did an EVO 9 OFH swap and installed a oil cooler during.

@llxkevinxll I appreciate the input. Same as Jet Hot, Swain Tech does not coat the internal portions of turbo parts (as I read on their site).As for your points #1 and #2, I agree I do not want to keep heat trapped in something that is trying to cool. Swain Tech also as a BBE coating that...

My 7 blade HX-35 center section has seen better days. I am getting a rebuild done, but before I send it out I am going to get it coated. The compressor housing is going to get a black powder, and the turbine housing a ceramic TBE (White lighting) from Swain Tech.My question is what coating...

Doesn't the EWP act as the thermostat? It wouldn't turn on until temps reach your set temp?

I appreciate the feed back! Scratching the 1/2 rad idea and going with -20 Lines. Sorry for sounding ignorant with the big turbo/ 1/2 rad talk for autocross. Maybe those goals should be for another car another time. This car will be street driven on the weekends.@ec17pse I would be interested...

Hey everyone,Had cooling problems last time on the dyno. My tuner could only get a full pulls before overheating. I have the car torn apart and have been thinking about overhauling the cooling system and want to get your thoughts.Let me start by saying I'm not looking for answers of why I...

Up for sale is a Megan Racing front strut bar brace.Good Condition.OBO $50.00 + Shipping/PP