Hi,
I Can see where the connectors are in the engine bay,
but what I am trying to figure out is the style of connector so I can get a female / male set and make a patch cable to relocate.hope that helps
Hey everyone,
Does anyone know what style of connectors are on the AC fuse box?
Some jerk put a AFPR where it’s supposed to be and I’d like to make a patch cable to relocate the fuse box when I go to add it back the summer.Thanks.
TIRE SIZE RECOMMENDATION REQUEST FORMPlease answer the following questions when requesting tire size recommendations.1. My car is a:
a) 1g DSM AWD
b) 2g DSM2. My wheel size is:
Diameter: 15
Width: 205
Offset: stock 1g3. My current or future suspension height will be lowered
a) One inch...
Hey Everyone,
I am trying to piece together everything to put AC back in my car its a 92 6 bolt AWD.
everything online point towards this as the compressor connector https://www.ohm-racing.com/product/ac-1-way-connector-evo-x-evo-8-9-1g-dsm
however the only thing around the back of the intake...
Thanks guys I ordered one off extreme psi last night thinking it was the same, it looks identical you would think he would list it as the rad fan connector
Does anyone know what connector type is used for the fan thermo switch on a 1G? i had a wire get brittle and busted the connector trying to remove the pin.
yes it click/thuds every time.
ive also put a spade connector on the solenoid and jumped it to the battery and it cranks every time. which leads me to believe its some kind of power delivery problem.
i have a wire across pins 3 and 4 right now and its behaving the same,
but do you know where to get one? i seen one on performance part part out but none seem to exist in new form.
-Will
Hey Everyone,
looking for ideas.
right now i have the clutch position switch un plugged and the starter relay jumped i am getting an intermittent no crank
when i probe all pins at the relay during crank, I am seeing battery voltage at one of the vertical pins (3 i think) but none anywhere else...
Shot in the dark, but I got a car with a wideband with no markings it goes into a aem gauge which I hope means it’s an aem ( I’ve heard they’re crap though) would anyone by chance know what model this is?
sensor is from 2012 era I tried looking at some sensors on line didn’t see any with...
Hey everyone I was prepping my cylinder head last night and made the mistake of spraying the deck with Chlorinated brake clean. I have black nitride SS intake and inconel exhaust.
are these valves junk now? Is it worth to continue?
i get what you saying because the valve is nearly closed and the piston is moving away after the first few points my scrutiny went way down so they are probably wrong.
i had to advance the intake 1/2 or cam degree after this,
this was my original p to v
20 BTDC .375
17 .323
14 .288
11 .268
8 .229
5 .206
2 .182
1 ATDC .176
4 .162
7 .155
10...