Thanks for sharing the info! I ended up going with the Kirkey Road Race aluminum seat because it was the narrowest one I could find, and it barely fit. The previous owner installed a welded drag roll bar that fit around his Kirkey drag race seat, so I had limited room/options because I didn’t...

Beautiful! I would just recommend verifying that your dipstick tube is just barely touching the manifold blanket. I didn't persuade my tube enough and it ended up touching and rubbing up on the blanket enough so that it wore a hole in it over time. Please don't be like me, and keep your...

Some soldering work to extend some wires for the fluid level sensor to the 3g brake master cylinder and the IAT sensor

Installed newish clutch master cylinder, and new oem 2g clutch slave cylinder to go in the 2g trans. Still need to bleed the clutch

Wired in my ethanol sensor

Undid the previous owner’s fuel pump re-wire with my own re-wire with fresh relay.

Messed with my oldie Extreme Motorsports SMIM…

Just recently coming back to my project after a one year hiatus due to life/adult stuff…Started easy by replacing some old, crusty, hardened boost gauge hose with some fresh hose.

I just did this mod on your recommendation, thanks @1990TSIAWDTALON !!!

Good job on the bearings, I never look forward to doing that job. Those cursed snap rings hang me up every time!

Looks nice!

If your Baer big brake kit was anything like mine or any other Baer big brake kit that used the PBR corvette sliding caliper that you referenced, then yes I would say that the rotor was indeed a Baer one-off simply because the rotor would fit onto your hub without the need for a hubcentric ring...

I had to file down the ribs on this oem gray mitsu 1g 6-bolt cover, as well as the oem gray mitsu 1g 7-bolt cover that was on my 1994 talon.

I recently filed my 6-bolt lower tb cover down to clear my Fluidamper. It broke my heart to do this to a fresh new oem part, but it had to be done. I basically had to file it totally flush and completely eliminated the rib protrusion to avoid the rubbing.

Congrats getting the website up man! The site is still a little buggie though? I’m not really a computer savvy guy, but I tried shopping the site but kept getting “Server Error (500)” on pretty much everything I clicked on. Can’t wait to check it out again though once things are working!