DSMtuners is a massive archive of DSM information - but more importantly, it's a COMMUNITY! Join in and participate with other DSMers, and invite all of your DSM friends to make this place their home. Chat with others, create a build thread, post questions and answers. Get involved! Logging in will also remove many of the advertisements, along with this notice. ;) It will also allow you to view images in threads.
You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
So I've been quite busy with work but have spent whatever free time I have piecing her back together.
Every little thing takes so long to do, having to figure out how it's supposed to be but I'm crushing them out one at a time. Also not having...
The float inside might be stuck in the down position. When the fluid level is above the sensor, the circuit is open. Below the sensor and it completes the circuit triggering the light to turn on. I would remove the tank to test continuity in...
Wire loom link, for 1 wire, get the smallest, 1/8"
shrink tubing
and a small bullet connector1. Remove the old crusty wire cover
2. Repair the end of your wire by crimp/soldering a new bullet connector on the end, add wire length if necessary...
I like that color! I'm tired of Red, Black, White.....but I would like to have all of my "american" 1g's running at the same time, Red, White and BLUE!!!! :thumb:
Less coolant in the mix will boil at a lower temperature. Your gauge wasn’t reading high, so perhaps it’s not overheating, just over pressuring. You can also remove and check the temp sender resistance. I would suggest you drain the cooling...