Very nice !How would this compare to lesser priced coilovers such as Feal 441, BC and the likes. They tend to hover around the $2k mark.What do the Ohlins bring for an additionnal $2k?
EDIT* Just saw your 420a. Not sure if the following still applies...Like 5th gear cruising speed, under 3000rpm?Sounds like one of these notorious ''P0300 after clutch job'' issues. Since you did an Auto to Manual swap.Just food for thought...
That's a bummer! when your rebuilt the engine, did you use new machine head bolts from the hardware store on the oil pan? IIRC, one of them has to ground down a little to avoid interference or your risk shaving the timing belt ever so slightly until catastrophic failure. Kinda like whats going...
I just submitted mine.Canadian
Jan 1998
4E3AL54F4WE093486tsi awd 5spd
150,000 km
Pewter blue pearl
Gray leather/black dash
Sunroof
No power seats. No ABS. No rear LSD
Yes, I visually verified the positon of the fork in relation to the window. It's ever so slightly offset to the driver side. I did get my flywheel resurfaced, and when i measured the step height with a quality caliper (starret), i was reading .610 exactly. However, being limited to just a...
Hey all,Quick question, my clutch pedal goes to the floor after a clutch job. New TB and fork with very low miles OEM exedy replacement kitI never disconnected any clutch lines however while I was doing the job, the slave rod feel off. Not sure if that matters?Should i be worried the exedy...