Hi guys so going to make this short and sweet. drove the car Monday and when getting into the throttle normal cruise the car was bucking hard. It eventually came to a point where I had no throttle response, stalled as soon as I pushed in the clutch. had laptop and hooked up to see what link was...
No offense taken at all. I'm new to ecmlink and still figuring out all it can do. By no means do I consider my self good at tuning with it. I am going to be paying for someone to tune the car next year. the tuner told me to install flex sensor ,get everything working correctly before I brought...
@GST with PSI was just looking under the configuration tab and did not see where to tell ecu that there is ethanol sensor installed. Red the wiki and here is what it said. Does this sound right?
basic ethanol sensor functionality (i.e., automated global fuel adjustment). Once checked, the ECU...
You are absolutely correct I do have some work to do on the tune. Have a set of 2150cc injectors and planning on running E85 first thing next year. Getting a dual map tune on the dyno. So didn't want to spend time perfecting Wot on 650s just to throw other injectors in and start all over. Was...
So an update. I uploaded the file that @GST with PSI sent and it worked. Attached a file around 230 seconds I did a 1st-3rd pull. she maxed out boost about 28psi and dropped down to 22psi at redline.Have to tweak the Base DC table for sure. Thank you for all the help guys. this site never...
I should have wrote that a little better. When I said top port tee'd in with pressure source at compressor housing and bottom of port of wastegate. Top port meaning top port on the side of Ingersoll Rand solenoid that has two ports. It is setup how the wiki stated and pictured under using both...
I will for sure hook the vac lines back up to controller and add wg values to the log. Probably taking the car out tomorrow if it does not rain. Thank you for the reply.
1998 gst with 7 bolt motor, FP Black and external wastegate off the manifold. hooked up the Ingersoll Rand controller using both top and bottom ports the way that wiki says. top port T'd into compressor housing and bottom port of waste gate. side with only one port is hooked up to top of...
I have an evo 8 16g turbo. My question is, could i swap an evo 3 16g exhaust housing onto the evo8. That way I wouldn't have to get a twin scroll manifold and fab up a downpipe.
i mean i have the knowledge and patientce to do it but money is the issue. that and i asked because i didn't see any post about doing it yourself so i decided to ask. but your right doing it yourself is very risky. so ill just save up and send it out.
so i've got a 90 gsx with a non-eprom...my question, is there anyway to convert your ecu to an eprom by your self? i know that dsmchips.com and ecmlink offer a conversion but i dont have money for them to do it and i can't have the car down while i send out the ecu.any help is appriciated...
It showed one count of knock at one point..but it never showed up again. i got to go to work soon so when i take it to work ill try to see what my other problem is. hopefully i don't need a new t-case of something.