i know i am reviving a post from nearly 10 years ago, but i want to highlight one thing so no one makes the stupid mistake i did. the washer on the bottom of the turbonetics 30326 dual port wastegate holds in a plastic bushing in place the plastic bushing pushes on an internal seal and seals the...

i hope you were working on an intercooler shroud and did not leave that cardboard on there. lol

there are DSM's in indiana junkyards from time to time. at least around Indy and Seymour areas. or you can hit up Indiana DSM Tuners on facebook and ask if anyone is parting out a shell.i live in Seymour, btw

n/t's are louder due to not having a turbine housing to mute the sound.this is also why my 2.5RS is louder than my turbo Eclipse.for more "spool sound" [compressor sound, which would be the intake side of the turbo] get an rid of the snorkel intake and air filter box. get a hard preturbo...

mandrel bent pipe, a couple of resonators, and a Cherrybomb Vortex muffler out back.no restriction, and you can feel the bass rumble in your chest [the deep, throaty sound everyone wants].source : my exhaust set-up, 2.5" pipes. not sure how 3" will sound.

does anyone know the answer to my question?

List: Brake Caliper Bracket - 2006 Mitsubishi Outlander | O'Reilly Auto Partsare these the brackets you bought from oriellys? they are listed for the rear, that's why i'm asking. just want to confirm before buying.

mod has been done. view awesome links in post #7.looking for max spool and torque with planned build. AutoX. no one will know the benefits or negatives until someone does the mod AND REPORTS BACK about the success or failure.i am doing the community a favor by pursuing this. please stop...

i told you i couldn't find it. and you sir are BOSS. thank you.

i fail to see where anyone said this was a engine build plan discussion? please help me out with this issue, dont suggest an alternative route to just bypass the issue.BogusSVO, are you talking about Moroso A&B Epoxy? the Moroso website says it can only be used up to 250F, isn't an intake...

thank you for your thoughts. link to epoxy?i see where you are coming from about the 1G head, but that's not where i'm going. i am planning to use a cyclone intake, 2G head, 7bolt crank, and E16G. fast spool and torque is what i want.

i doubt this is a repeat thread, bare with me. :thumb:i'm been searching [dsmtuners, dsmtalk, ecmlink, google all the things] this intake for about three months now, off and on. i know it bolts up to a 2G head. i know there is a step between the 1G intake sized ports on the cyclone and the...

revival bump, someone please answer this question. i have the same question and don't want to start a new thread.

solson for the win! BOOM.

i'll be bringing the geo actually. SEE YA THERE! :D