You will need some type of base bracket to bolt to the floor to give you a level surface. If you look at the floor pan of our DSM's I know 2g's seat bolt locations are not flat / square. I used Wedge Engineering seat brackets. They will require an exact measurement of the base of the seat you...

I like it, however I think I'd like it more if the sides didn't have that vertical hole. It give it an almost Evo-ish look.

I'd like to contribute my engine bay to this thread. It isn't 100% done and certainly not up to the level of some of the cars in this thread but this is my first attempt.

Does anyone know if it's the same lines for a 20g turbo?

That looks great converted and wingless. I'd love to see it with the orange section of the tail lamps tinted with Niteshades.

What about something like this? I've seen this on Supra's before painted black. Looks very clean.CCG UNIVERSAL 6" x 36" SMALL PERFORATED ALUMINUM GRILL MESH SHEET SILVER | eBayI hate that chicken wire crap you normally see in bodykits and the like. Cheapens the appearance.

The complete door replacements look nice... Will they 100% accept factory glass, power windows, latches, handles, etc without fab work?

The ultimate rice. Looks like CF, none of the benefits and barely any of the cost.

I'm not sure why there is always this great moral debate over carbon fiber doors. Yes, your factory accessories have to be installed onto the doors to make them work. I'm not sure why that is a non-selling point, for me, the fact that factory hardware can be installed is a plus. I am also...

np. they are also producing the "scoote" hood from the RX-7 which has the three vents on each side at a sort of angle. I'm going to be purchasing that hood and selling my OEM CF hood.

Importfan used to carry the eclipse hood with TRD - supra style vents on it. I ordered it for my car, received it in the mail all smashed up, and sent it back. I waited 3 months for a replacement and finally ended up with an OEM style, i called them and they said they stopped making it, then i...

I'm still wondering about the speedglass, if anyone has it and if you can roll it up / down like normal glass.

check ebay, VIS, chaser aerodynamics, andy's autosport, google, NOPI, etc etc etc. theres also one called goodrich or something they used to sell in J.C. Witney it was real ugly with a giant subaru WRX - looking scoop but i'm sure if you search for 10 minutes you can find more than i found in...

Looks great. I like the mesh style wheel. I just got my ADR 20 x 8.5 +40 offset trying to figure out tires now. Can you take some pictures showing the wheel directly on (from the front, down the side of the car)?? I'd like to see how flush they are.

I certainly don't like it. It looks like something cheap you would buy at home depot. :D