Ok so i just ordered a new cable from DSMparts and apparently i ordered the wrong end so i go down to the local radio shack and buy a serial cable that will convert the female end to male end, but when i hook it up to the diagnostic port and start the car neither one of the programs will log...
Thanks for the advice guys, it helped i found my problem. After i psrayed the engine compartment down with soapy water i found all 4 of my boost leaks car runs much much better now thanks.
ya the car is firing on all four. The only reason I question the timing is I suspected that in the beginning and brought the car up to tdc on #1 cylinder then moved the cas back and forth and would get spark. I have my emmsisions removed on the car and a new boost controller. I have tested...
okay something weird is going on i got my car running last night after working the bugs out of it, the new engine has new pistons bearings, emissions removed, slowboy boost controller. When the car start you have to keep your foot in it to keep it running and it stumbles and spits. The higher...
After 3 days of guessing and trying different options i figured out that i had my cas plugged into the wrong harness duh!! :|Then last night the car would start but i would just limp along run uneven and just plain crappy, so i checked all my sensors chekced for restriction in the intake...
Okay i just rebuilt my motor a little while ago and have got it back in the car and ready to fire ,but the only problem is that i have no fuel or spark. I have fuel up to the rail , but my injectors won't pulse. When i discovered these problems i searched through this forum and a lot was...
Sorry i did not reply sooner i have been busy with school, work, and trying to get this car fired up.Well bored .30 over, Ross forged pistons, Arp main studs, head studs, rod bolts, BS removed,1990 eprom ecu, slow boy racing boost controller, walboro 255 Rewired, Adjustable FPR, EGR and...
On my head somebody had tried to take the cam gears off but instaead of using the hex on the cam itself they used the lobes :confused: so i took it to a machine shop and they polished for me.