7 Bolt Magnus Street intake with Nitrous bungs, trumpet runners, phenolic insulator and 2 gaskets ( used ). No cracks. 64mm TB opening.$300 OBO + Shipping and Pay Pal Fees
Make sure you wrap the end of the hose you'r cutting with a good tape. I use a reinforced packaging tape ( link below ), wrap the end tightly, put a " cut here " line on the tape and use a cut off wheel and other members suggested, cutting thru the stainless and PTFE, ( make sure you make a...
Fastest way for a response is to text Jim at 517 four 0 four 2976Fidanza Aluminum Flywheel, 2G, 7-Bolt , FWD, P/N FI-161781
https://stmtuned.com/products/fidanza-1g-2g-dsm-lightweight-aluminum-flywheels?variant=685799931913Needs friction surface ( replaceable), best price I found was $75...
You cannot polish that much material off a crank and keep it round. If you think of the process,a belt is pressed against a rotating main, it's not backed up and can flap somewhat, it is no where near as accurate as a grinder at a fixed position. If there is somewhere you can get it polished...
I bore gauge ( set with a calibration ring ) the main bores, cap torqued, no bearings, mic the crank ( 4 places per journal ), mic the bearings ( with the correct style mic ), do the math and mix and match the bearings to get as close to the clearance I want ( note: there is very little...
Agree with bastarddsm, plastiguage is not real accurate but if that's all you have, I'd be really concerned with #1 and #4, I run my 2.3 at .0025" @ a 600Hp level. For what it's worth an old rule of thumb for a modified engine is .001" clearance for every 1" of main diameter, since DSM mains are...
Fastest way for a response is to text Jim at 517 four 0 four 2976Fidanza Aluminum Flywheel, 2G, 7-Bolt , FWD, P/N FI-161781
https://stmtuned.com/products/fidanza-1g-2g-dsm-lightweight-aluminum-flywheels?variant=685799931913Needs friction surface ( replaceable), best price I found was $75...
If you have room I'd go with OEM, if you need a low profile I'd go with Hayden. Hayden is a supplier to many OEM's and the design and testing that's required for OEM is significant and translates to after-market. I had Mishimoto fans mounted to their shroud and the legs of the grill that...