Car needs to go. Someone buy it.

1990 Eagle Talon Blown engine hole in block. 2.3 not sure whats salvageable. 4 bolt rear installed original 3 bolt rear Jacks Built Transmission Speed Density setup LC1 wideband ACT clutch 2 walbro 255 fuel pump on full blown hanger FMIC Head: All parts new. 280 cams adjustable gears Piston...

I had a full exhaust with a side exit electric cut out. I'm going side exit only once I get my rear subframe back together to save weight.

Thanks. It's been done. I've got 1500 miles on the build. I've seen 54lbs/min but haven't ran it yet :/wH1c

Here's the final manifold. Forgot about this thread!

My tire stem kept leaking on my BLT so I made one that wouldn't leak!

Seen it on CL. looked like a good deal.

I believe it's only active by the CAS.

Look for my posts in this thread. I have a chart somewhere.

I've tried multiple cameras. Needs a special lenses for the exposure. I've never had any videos turn out.

If your trying to get some puddle action you won't without spending thousands of dollars.

Dacowgod is tuning my car. It's really lean at at -74.6 correction only under WOT.

I'm trying to get my 2150s dialed in. I've been told I have a fuel problem under WOT. My fuel setup is 8 an feed 6 an return 2 Walbro 255 on a full blown hanger rewired stainless fuel lab filter fuel lab AFPR FIC fuel railI cleaned the pump socks and the tank. I thought that...

Have you check all the pulleys and belts?