FS: 2g GSX PartsStarting to part my car out and this is what I have available off the car as of today.Located at 08230PayPal: [email protected] have item shipped 2-3 days after payment.
Parts sold as is.Parts off the car:Found this upright and don’t remember much about it other...
FS: 2g GSX PartsStarting to part my car out and this is what I have available off the car as of today.Located at 08230PayPal: [email protected] have item shipped 2-3 days after payment.Parts off the car:Found this upright and don’t remember much about it other than it’s brand new...
All new parts for a 2g:
GST gas fuel filler neck #MR271612. $100 shipped/paypaledRear Hatch latch #MR358944 $25 shipped/paypaledValve cover that was professionally disassembled, baffles removed, cleaned, new baffle welded, and the powder coated red. Best job I’ve seen. Also has AN...
Mut-II with case and tapes and manuals. What you see is what you get
$250 shipped/paypaledRebuilt alternator with dsm performance 2gAL pulley installed
$55 shipped/paypaled
In theory your professor is probably right but in real life he’s wrong. I’ve hit over 100% more times than I’d like to admit in my Subaru and on stock turbo/injector STIs it’s not that uncommon. I’ve seen people post logs with 110+ IDC
Guess I’ll try some 2000grit paper and take it to a local machine shop for their opinion. Worst case I’ll just send it to delta if they will fix if for only 125. If they will do it for that cheap doesn’t even really make financial sense to try and have a machine shop polish it
It’s only the one cam and that one lobe. At the end of cam there is alil pitting too but it’s not on a lobe. I usually wouldn’t run something like this if it was all the lobes. I really don’t wanna spend too much money on them unless it for sure will make it a 100% since I’m pretty sure I could...
I have a built motor with high mileage that I’m going to do a quick rebuild since timing belt tensioner went. Going to rebuild head, reseal engine, rings, hone, bearings, etc. Car is a weekend toy that I do DD occasionally.Took cams out and they had some surface rust that cleaned up real well...