Rest In Peace Curt Brown! So sad to hear this :(

:hellyeah:

If this was me, I wouldn't even drive the car until I replaced the Thermostat and Cap. Just cause if you keep driving it like that, I'm sure if you don't need a head gasket now you soon will. Not only that with the temps being so cold up here that head is gong to warp do to the heat of the...

Very nice

Sweet write up, can't wait to see how everything works out. I'm just in the process of doing a front brake upgrade. I was going to spend the extra buck on the Stoptech Big Brake kit, Just cause I did this upgrade on my old 02' Audi S4 and they were amazing, they best brakes I've ever used. So...

Just sent a few pics of my car.

I had a similar problem and it ended up being my IAC. My car would start and run and would not idle, nor wold it stay running at all. It also revved up to around 2k then stop idling. Give it a try, maybe its not the issue, but give it a try. Take the IAC off and check the tip of it to see if...

I've had the DDM HID's for about 4years now and haven't had any problems. There straight plug and play; all you have to do is run the power to the battery. I went with the 35w ones and haven't had one problem in the 4years I've had them. They make a night and day difference over the stock bulbs...

with

I kind of have a problem with mine shifting at higher rpms. I have a stage 3 shep trans with all the upgrades, bushing kit throughout. What kind of flywheel are you using? Check Road Race Engineering ( RRE's Clutch And Flywheel Tech Info ) look towards the bottom of the page. I'm using the...

I put on a Fluidampr Harmonic Damper today and before i put it on i spun the crank (six times) by hand and made sure all my timing marks where on and they where. So i put the #1 cylinder to TDC and lined the crank pulley up with the timing marks on the crank sprocket. I put everything back...

Thanks for your help. I just called my local Mitsubishi dealer and they had both lines. Cost $40 for both. Back in business.

I need to know what the part # is for both the metal lines? I would like to get OEM ones.

So i found the leak that was causing power steering fluid to leak all over my down- pipe, control arm etc.. On the power steering rack, there are two little pipes that run off it. The one that was leaking is the one that goes from one end of the rack to the other end. Where can i find this...

Thats a RRE "No Name" Flywheel heres the link Road Race Engineering's Eclipse Drivetrain Upgrades .Its mid way through the page and theres pics too. Not sure about the clutch disc. But the pressure plate is most likely a Spec.