Check the links in the page below:
https://www.dsmtuners.com/forum/articles-manuals-documents.262/page-2
90-90 Electrical factory service manual:
https://www.dsmtuners.com/threads/1g-dsm-1990-1991-electrical-factory-service-manual.517382/
FYI.
Download Links to all of the 1990 Service manuals are in the resources tab of this web sightGood maintenance walk thru plus the links to the service manuals:
https://www.dsmtuners.com/threads/dsm-maintenance-guide.476550/
I see you are in Ravensburg De. Nice area, visited a few times.However, RTM has a rebuild service for 90' AWD DSM calipers. They should be able to send you a rebuilt set with a core charge until you send yours back. Shipping may make this not worth it though.Link to 1g caliper page...
Thanks for the reply. I double checked the LEDs listed in Buds post and they are the same.
T10=194
T5= (PC)74
31 mm feston= 3175Also, I just reread his post and he did not change out the cluster lights to LED bulbs.However, I was thinking today and realized that there is a timer relay for...
Overview:
I am changing the entire car to LED lights. However, I had an issue when changing the interior lights to LEDs last night. I changed the dome lights to 2xDE3175, the footwell lights to 2x194 LED and the in dash door open light to PC74 LED. Ash tray changed to 1x74 LED along with the...
This link shows all the timing cover bolt lengths. I do see it is for 95-96 though. 97 may be different.
Look about 3/4 to the end.
http://www.vfaq.com/mods/timingbelt-2G.html
So my take away from your reply is that the SD cells have zero input in the value shown for the Omni 4 bar. It seemed like every time I adjusted the SD table that the Omni reading would drop a relatively similar % as the table change, so I assumed it adjusted its reading for some reason.Thank...
Please help, I think I may have adjusted myself into a hole.Spent the last few days building aluminum intake pipes and then made the changeover to Speed Density. Car ran fine with new intake pipes and with running on MAF, idled fine but no long drive, decided to change to SD before that.MOD...
Here is a link to the one I got off of Ebay. I don't see a locating pin in the pictures. Have any tips on alignment?
https://www.ebay.com/itm/111519430640Response will probably improve over the housing that is on there now. Wastegate hole is trashed.
Question,I am needing to replace my exhaust turbine housing on my 14b, it is very melted and cracked at the wastegate flange. Too much to just add the larger flapper. So, I have a new 7cm housing on the way. Is there anything else that I would need specific for this? Already have all of the...
Tim,
Thank for that information. I was hopping that you would get a chance to look at these pictures.The transmission should be a 1990 transmission, I'm guessing that the 5th gearset assembly is going to be a hard find, I remember the synchro is impossible to find new. Is the input shaft the...