This factory alarm is new to me when I got the car there was no remote included so I bought one and programmed it I'm not sure how its as posses to work tho, the onlylights that flash when I lock or unlock is the interior lights

My horn does not sound when I arm my car. if I press panic the horn sounds but I want the horn to sound when the car is being locked and armed

Hey guys my factory alarm works but when I press the remote lock the doors lock like they should but I don't hear my horn honk to confirm my doors are locked even if I press the remote twice is this possible on the 2g or is there no horn sounds ?? Also when you press the lock are the headlights...

I have a volt meter but how do I check a parasitic draw like what do I connect the leads to?

Hey guys need some help here so my car is at a shop for a alternator And the guy says my battery is Completely drained over night With the car off, any idea on common place to look for where this power draw is coming from?Rix

I have that same prob I'm thinking I have a major boost leak

Yeah that's for sure i miss my drive thru haha do you think that door wire harness is easily changeable and easy to find?

....Ok Great news this issue has been resolved!!!!!! I can't believe what it actually was well i used to have the Lamborghini door conversion kit on and had to get that wire harness extended well i look at that harness after following that wire and guess what I found??.....it was broken off I...

I can't find any issues that stand out I have had the dash out to fix the heather core while ago are there anyway to access those B related connectors that relate to pin 28 wire without pulling the dash out again? And when you say prob the wire by the door side which one the 27 pin one or 28 pin...

Ok so I connected one wire to the body of my car and the other end to pin 28 like you said the window now rolls up with i press the switch up that way but when I try to get the window to roll down it does not work any idea on this?Rix

Ok soo I got some news when I have the volt meter red lead connected to the Green/red strip wire of pin D-11 and the black wire from the volt meter grounded to the body of the car and then with the switch held on the up position I get 11.78V when I let go its 0V and when hold the switch in the...

I have a test light but its a ac test light it does work with DC voltage but I do have a volt meter with ohms and all can I use that instead?

Sorry im new to this electronic stuff haha The wires on the blue connector in the pic above looks like the wires in colour with the ones going to the harness that plugs into the master switch in question, and the one 2 wire cable you want me to disconnect is that one that I used to hook a 12v...

What do you mean by do you have the connector hooked up going to the motor itself?? I have every thing hooked up liked it would be normally then I unhooked the big blue connector from the top control module and put the volt meter to 27 and 28 like the pic above is the way I did it wrong? It's...

Ok so when I check the volt for pins 27 and 28 when I press the switch up I get a volt reading of 0.018v and when I press down I get a reading of 0v's