Williams complete auto...... 443-455-9039..... one of the owners drive and builds dsm. just be staight forward with yours plans and what you want. very good prices and nice work.
if you failed hydrocarbons , that is unburned fuel. check your tune ! when i passed emissions in maryland. i had 750 cc injectors ,3 inch exhuast from turbo back , gm maft , safc. i set it up to run 14.7 a/r from idle to 2500 rpm where they ask me to hold the engine speed at during the test...
i picked up a 1995 talon with 97 front end. it'a an automatic. it is having weird tranny problems. my question is even thou it has a obd2 connector in it ,can i use a snap on scanner to pull tranny codes or will i to use a volt meter or something else.
there is a place out side of b-more called pmr racing that will do it $600.they use mitsu timing belt and seals. and gmb new water pump. 443- 928 -6302 .you need to leave message for him.
Well i brought a set of fic 1600 cc injectors from a guy that had them on his car with no easy box . on his car they ilde perfect. cruise nice with no hiccups.On my car we couldn't get them to even idle right.I drove up to ecmlink and talk to them about the problem i was having and they told me...
There is a 6262 that bolts on to the dsm . i saw a guy up capital run 10.20 with it. i also brought the same bolton option from import evolution. guys name was ryan. be warned, dsm housings on that turbo is very restrictive , i started out dsm housing than ended up buying a t3 hot side to...
I 'am getting some opinions on this product from people that run them with pumpgas . some real world knowledge. just because your car runs fine with those injectors dose not mean the next one will.That was for the guy with the 1450 cc, i did not mean to duplicate the post my system crashed...
I have searched on here for those running pumpgas on these injectors.What gobal and deadtime settings are you running on pumpgas? How do they idle and cruise ? what are you using to tune them with , i have seen plenty of e85 post. What i haven't seen was some pumpgas post for bluemax 1250 cc...
i would like too see those who run pumpgas only on these injectors, What are gobal and deadtime settings. i have seen plenty of e85 post on this topic , But hardly any for pumpgas How do they ilde? what tuning system do you using to tune it ? i 'am using ecmlink v3.
You can email. ecmlink about you questions about their product. they answer quickly. also surf their site alittle bit , there is tons of information about ecmlink onthe site as well as videos. follow the advise from some with experience.
Yes i was asking because i want the ability to run my fic 1600 cc. i thought it would have been a great pumpgas and e85 injector . with the ability to run two switchable tunes through ecmlink. because 1600cc through ecmlink are still a hit or miss. and even 1450 cc the same.. i'am not sure about...
A mass air flow has a wire it that heats up to 390 degrees , when passes over it to cool the wire down ,it heats it self back to 390 degrees that is how it measures air coming into the engine.it gets feed back from the o2 sensor. if one is off everything is off. there are other sensors that...