Mine is a billet 20g (TD06 compressor) with TD05 7cm turbine housing. I haven't been able to do alot of testing yet. From reading this I should have went with a anti-surge comp housing but I didn't.
I have an extra 1g harness that I pulled the wires out of. If you do it right the female connector will come out of the plug and they fit snug on the back side of the 1g ECU connector. Then use some heat shrink over the connectors. I believe the smaller spades will fit fine also.
Have you tried to flash with your Vag-Com cable. Someone on dsmecu tried it and it actually worked with Evoscan. He said it wouldn't work with ECUflash but would work with Evoscan. This was all on an Evo ECU though.
What flash cable are you guys using? I need someone to help me with a very basic SD tune. I just need to be able to drive my car for now. Nothing special.
I started to use that pinout as the 2g reference but then I realized the the 95-97 wiring diagram and 98-99 differ a little. I searched and searched for hours trying to find a 98-99 only pinout and it seems the only one I could find was the one below that compares a 2Ga turbo and a 2Gb spyder...
Good luck bro. I was in for 5 years and the only advice I can give you is to watch out for your battles but watch out for yourself first. It is a brotherhood without doubt but never expect anyone to go to bat for you. They might but from of the things I witnessed was NCO's not wanting to lose...