I know that groove is normal over the life of the vehicle but it was grooved in less than a 1000 miles. That's where I'm lost. Like I said I already ordered the yoke and another carrier bearing and hopefully it was just a carrier bearing causing the premature wear. When I get it installed and...

Ok like the title says my transfer case is still leaking at the output seal with the recall yoke installed with just over 1000 miles on the car after complete rebuild. Just tried another seal thinking I might have damaged it with install but after I remove the driveshaft you can see a groove in...

Ok first I'm not asking for what setting I need to start with I'm gonna be running EVO 560s so for injectors I need to start with -10 to -12 correction but I'm also gonna be running a 2g non hack so with what people have seen how should I adjust my starting point? I've read add 5 for a hacked...

Ok finally had time to check my tcu and the capacitors were leaking.[IMG]http://photos-b.ak.fbcdn.net/hphotos-ak-ash4/s720x720/320255_181301335284872_100002150209373_373149_145538247_n.jpg[/IMGOk I got a line on another tcu but if it doesn't pan out I've been reading about this kiggly shift...

Ok will do after work tomorrow thanks.

First I'm not sure were I should post this but I have a 92 talon tsi awd auto. Mods are a 16g turbo with a 17 psi wastegate and a manual boost controller set on its lowest setting. I have a front mount intercooler, k&n filter, gutted cat, "fart can" muffler(previous owner), 255 fuel pump and...

If your trying to save money stock would be fine for now.

One is under the battery on the transmission and the other is behind the motor attached to the transmission as well. Hope this helps.

Mounting bolts for those brackets?

OEM turbo applications almost always recirculate the bypass valve because not everyone like the psssh of a venting blow off valve and manufacturers are not just selling cars to us speed freaks,they have to apeal to the general public. Either valve will do the job of allowing the boosted air to...

The car in the video did that have an intercooler? Or did he mount a hidden air to liquid under the supercharger? My old boss did something like this but with a pontiac bonnaville, 3.8L v6 supercharged motor with custom single turbo kit. Badass when it was running it made my evo look like it...