I made this video. I hardly build these anymore, unless its for a business. The problem is that too many dsms have issues that cause turbos to keep going bad. I started off building turbos for these cars, but later left the scene because 50 percent of the time the turbo will have an issue based...
There is a dowel pin on the crank for the automatic which the manual transmission cars don't have. The way to remove that is to pack the hole with grease and hammer a wood block in it. I read that on this forum and tried it. It worked well.
There is not enough room for it to fit not to mention all of the other work you have to do to make the drive terrain work even if you were able to crank it in.
Based on your horsepower target, you should probably go with a gt35r. You could upgrade the turbine housing on you gt3076r and get closer to what garrett rates them at which is 580 hp. There the turbine housing options are .63, .82, and 1.06 in t3 form. The 1.06 is huge, I built a turbo for a...
We had someone make 414 hp(e85) on the 20g with tdo5h turbine and 449 (pump gas 28psi) on the tdo6sl2 20g with 7 blade billet wheel.
i had someone make 364 hp at 24 psi on pump. it seems like they get get close to the 400 hp mark with the tdo5h shaft being the limiting factor.
Your vacuum line is too large that your using on the WG. That one is subject to leak. I would also do a boost leak test.If that didnt show anything then i would say its the combination of your exhaust housing being too small and your wg being too small to handle the back pressure.You could...
The inside diameter is what is important. It doesnt matter what the hose looks like on the outside. If you drainline is not large and free flowing enough to drain the oil quick enough, then the oil will backup in the cartridge and be forced out the seals.
You should go with the tdo6h turbine if you go with a 58mm compressor wheel or bigger. I also dont like their bullet nuts because they are fatter than the hub of most billet wheels.Building a "badass" turbo doesnt tell us what you are trying to achieve. What kind of horsepower are you trying...
CLR still exists. I like to use gasoline to clean the oil off. To get the rust off clr works well, but it seems to leave residue. Purple power works well. Dont media blast it, soda blast it unless you have to. 1 grain of media your turbo is done. if the grain of media makes it to the engine...