I just finished rebuilding my head, guides, seats and seals, and I just installed 950 FIC injectors. Everything else was in my previous setup. When I attempt to set my base timing I can do so with the jumper wire grounded and I can set it to 5degrees BTDC, but as soon as I disconnect the...

I'm looking into running E85 and I was unable to locate specific information about a particular question. Seeing to run 25PSI I should run around 1000cc injectors, should I burn a chip that illustrates that there are 1000cc injectors or should I use the equivelant of 660cc for pump gas, seeing...

Still haven't heard a word for them.....But I did just recieve what I paid for, so i want to say that so I don't ruin their reputation. Bad Customer service though.

Noticable Difference. Or am i going through this trouble for nothing.

Did they stiff you?

Still no reply..I am going to call a shop locally to them and see whats going on with them. I can't imagine them getting away with this....Cant believe no one else has had a problem????

Do they even exist anymore. I ordered Rear Toe eliminator kit and, I recieved an automated email imediately saying the order is being processed. IT has been over a month and No product, no one answering the phones or messages, and noone answering my countless emails. Just wondering if anyone...

What is the tourque spec for ARP main studs on a 6 bolt block?

Most likely not, but possible shouldn't be dangerous knock tho (what problems are you expierencing with your ignition).

Yeah sizes are correct I used Oil Galley Plugs.

Good Luck

Amen.

After market cams would look a little less cast like (if that makes sense) normally with the company name imprinted on the cam. 2g heads have smaller intake ports with the upper part notch taken out (looks like a honda) so the fuel has more room to fall and create turbulence. other then the...

Need to find the clearence for those particular rings.. My wisecos was like .025 if i recall correctly.