What up every one, I'm looking to put on some wheel spacers to bring my wheels out a bit to flush up with my fenders. Has any one had good or bad experiences with these. What is a good size to get. I don't want to over do it just flush it up a bit.

Looking to meet up. Any one down.

I am having the same thing going on when i accelerate. So any help on what to check out would help alot

Any one else around the area. Looking to meet up on a sunday, maybe meet some fellow members

I tried to find what you were talking about but had no luck.Now that is a busy cockpit, but looks great

Thank you for the help, i plan on doing the boost leak check, checking my plugs and wires, i jusy wanted to get a few more ideas so i could chase a few things down instead of one thing then post, one more thing then post. I have not really got to really dig in to it yet. But i do know it drives...

That sounds like a good idea. Now i have searched for the location of the knock sensor and what i have seen is its located on the front of the block and plugs in by the fuel rail. If i am wrong please guide me in the correct direction

Hey guys, need a little help. Hope you can help. I have my 96 gst. Drives perfect untill it goes in to posative boost. When above 0 on my boost guage it hesitates alot and if i dont let off it feels like fuel cut but im only at 10lbs. So i am looking to fix it and wondered where to start. I have...

Yes

Ok that makes sense, thank you for the advise

i am looking in orderng a set of strut tower bars for the front, rear and lower. i have a spyder and was wondering if they are the same or if i need a diff one if i can do one at all. any one installed before on a spyder.

Ya I still have that trim piece but i don't trust it to hold a drink, not a tight fit and the lid to the arm rest falls and knocks it over. I was looking to maybe fab something right behind the arm rest. I don't use the back seats for anything so I wouldn't have to worry about it getting hit. I...

I was wondering if any one has custom made a cup holders in the 2nd gen. I am looking to do something for 2nd cup holder. I have a idea but I wanted to see if this has been done already. If u have a use or pics please share

i have seen some posts on the cockpit but all the pics are either gone or links don't work. I would like to start a new thread for you to post pics of your cockpit. I am also looking for ideas for mine. Like I want to remove the airbags and maybe do something nice in the passenger side airbag...

Sweet, thanks for the help