Here is a crank log from today. The battery sat on a charger overnight and was showing 100% charge. I even tried starting it a few times with my jump box attached just in case. Still shows insane voltage drop during cranking. I already replaced one battery after the car sat because the...
1. Done
2. Done
3. Done
4+5. I'm not sure what is causing this. The battery is slightly low due to repeatedly trying to start the car over the last few weeks to try and diagnose the issue so it is sitting on the charger now. However this issue was present even when the battery was brand...
I have a automatic JDM VR-4 that I just can seem to get to start.The car was all stock ran fine but sat for about 8 months while I was doing some work on it and getting married and having a kid. Now, I can not seem to get it to start and I am not sure why.While the car was sitting the...
You don't need to measure the hose. AN sizes are based on 16ths, so if fitting takes a 3/4 wrench, it is 12/16, so it's a 12AN fitting. Something that takes a 1/2 wrench is 8/16, so it is an 8AN fitting, etc..So unless it takes a 7/16 wrench, it's not a 7AN fitting.
Yes, brand new from ExtremePSI. The crank however, I did buy from another member.When I got them though, the only way I had checked to see if they were correct was by checking the wrist pin size, which was correct.On the plus side, the shop gave me a hell of a price on the motor. I would...
Yeah, it's easy to think that, but I'm sure that if they see this post, they will think "That is exactly why I don't let people bring it their own junk." Not everyone would accept that the shop isn't to blame, and someone running around talking about how the shop screwed your motor up when the...
Nope, the shop that I believe you are referring to refused to build the motor unless I purchased only the parts they wanted me to use, and only if I purchased through them.At this point, I'm just going to go by the shop tomorrow, and bring it home. It either gets run or needs a crank, no...
I'd prefer not to name the shop publicly, as the guy has been pretty cool about everything so far, when he could have just given the motor back and gone "not my problem", but if you really want to know, I'll gladly let you know through PM the name of the shop. It's not a large local shop, but...
Well, I had that thought as well, and I asked the shop to verify that the rods measured as above to confirm we had 6 bolt rods, he said he had already thought of that as well, and that he had an OEM 7 bolt rod there that he checked as well, and that it was closer to 1 clearance, which makes...
I have a short block currently being built at a local machine shop, but there seems to be a problem with the rod side clearance being way out of spec.The parts being used are as follows:6 bolt block
G4CS 100mm crank
Manley 6 bolt rods
Wiseco stroker pistons
King Bearings
ARP main studs...