Mother of god! Thanks for the heads up.

Sorry to hear about your trouble with UPS. It is unfortunate how they can rain on an otherwise good transaction.What was the service it was shipped by? If World Wide Expedited, there should have been no additional feel, just taxes and duty if applicable. My order was around $300 USD and I...

If you use Extreme PSI, it may be worth while to select World Wide Expedited compared to standard. WWE waives the brokerage fee and all you will be on the hook for, like anything else you order, is the taxes when delivered. If you go standard and are willing to go through the hoops, you can...

Ugh, yeah, I think my oil pressure got of whack bringing it to redline. Need to hookup a oil gauge and make sure my pressure is good.ECMLink should be straight forward, is your laptop good for it? Did the usb drivers get installed properly?I got a new one from Nick in Ottawa.

Negative to the gasket.But, does anybody have a HX35 kicking around or got a line on one?

I've heard good things about Northside too. I think they are who drilled out my camshafts. They are also who we get to do our stuff at work.In other news, finally made it to the track and got 3 passes in over 5 hours! Best was 14.775 at 111.x mph.If all goes well, I should be at street...

Ya around this weekend?I might pop over on Sunday or if I finish early enough on Saturday. Mostly I am after trim parts.If you are ready to finally haul it away, I may opt to take one last scavenge and pull anything I might need. I got the space to finally store tons of stuff.

Alright, hit me up in the spring, I'll put it upside down so it gets dust on both sides ;)

I could just toss it to you for now and pay me back later. Would rather see it get used than collect dust on my shelf. I was contemplating putting it in the winter beater but I think that project is delayed until renos are done.

$200?Ran for two summers, no passes, only dd'ing, roughly 10k km. Both were brand new. 6-puck held like a champ! Only switched because I couldn't sell the southbend disc I had, so I bought a southbend PP to use it.

Need a 2600 ACT PP and sprung 6-puck?

When the hell did you move to Florida Sven???And what you need help with?

Anybody have a small 16g?

Yeah...almost funny. The good news is I have a new turbo on the way. Even got a twin scroll non-wg housing with a 3" vband on it. Might trade off my BEP housing and t3 manifold to get my hands on a twin scroll manifold.

Not sure, didn't even know it was going on. Not on Facebook so I don't hear about any events anymore with the Redline forums being down/discontinued (do you know what happened to them?)Figure I would toss this out here - Looking for a 7-blade HX35. I do not need an exhaust housing, just...