First I grabbed 4 cans of yerba mate and slept 3 hours. Went to a buddys shop welded waste gate mounting ear then other buddys shop and:Driveline refresh, 2 U joints/dog bones and caps replaced. Lobro fill with grease. Filled both carrier bearing bushings one with 3m window and the other with...

Replaced right rear caliper, Added sway bar, LSD Rear diff installed.Driveline refresh, 2 U joints/dog bones and caps replaced. Lobro fill with grease. Filled both carrier bearing bushings one with 3m window and the other with roofing silicone.Replaced MAF and CAS, cas to black top.Welded...

should use the firing order from year it is, Cas inversion setting may be applicable?you should wire an obd2 port into the jumper harness, I believe it only needs 3 wires to function properly (maybe 4)

driveline shot lobro shot? bushings also shot. u joints not great. swapped temp driveline.rear right caliper sized.modified maf (just messing with it), re idle adjusted.

Has anyone monitored rear diff temps on our cars?I was just curious what temp range I could expect it to get into. I know oil breakdown happens faster higher temps.For reference I'm wondering about a 1g LSD 3 bolt rear, but I imagine there's probably not a huge difference for average temps.

TBH it cost me $500 to get my turbo rebuilt. We put a factory new garrett on a 2g couple years ago and just the turbo was 1200.

1g we staple welded the broken sun visor plastic so I could re-mount the sun visor. The other day my buddy and I swapped out the driveline on the 1g. I greased the carrier bearings and used grease to soften the rubber on the bushings. The lobro joint is shot on my old driveline and I have been...

weird thing to care about. I prefer if my car is worth a big mac and it beats the brakes off of a v8.

Wish me luck boys, I just built an adapter harness. I am going 97 to 91. I think I have it ready to test and I also need to grab an odb2 port and solder that in.

This is my buddy B's car. I will ask if I can use his name later. Troubleshooting.Galant GSX Swapped to VR4 Engnie: 6bolt from 1G tsi Wiring harness not the GSX unknown what car its actually out of possibly VR4Link wouldnt connect. Pinout on OBD1 port did not have good ground to pin 12...

This is the Build Thread for Galant-GSX/SwapVr4. Reply below.

Hey 2G guys.. this LED set works alright. I installed the low beams and now I can see!fahern led hb3/hb4 I didnt have the link handy the other day, just found it in my old order cart. 60$

Installed the drop in LED bulbs with ballast for the low beams.. I can see, so thats nice. Fahern is the brand, No issues so far been running them for couple days.

Install LED low beams, nice improvement. Need to install usb charge ports and route for tablet and phone. Need to find a tensioner bolt for the ac and replace alternator belt