I thought it was in the overflow tank?My memory isn't what it used to be.

Pretty much. I do't know if there is any differece in some of the connectors, the way the solenoids work, ect.. It would be nice if it is as easy as wiring the three plug tcu up.The ohm difference between the solenoids won't matter?

I am in the process of doing a manual to auto conversion. I have most everything I need, but the donor car's harness as been cut. The donor transmission is from a 94 and used 2 plug tcu. I have both a two plug and a three plug one available, would like to use the three because it is an eprom...

no longer for sale

Newengdsm.org

If there is a failure rate, than there would be a certian point at which it will become more common, or an average point. I do totally understand the fact that there are a lot of other variables in place, but in most cases it's appeares to happen mid 30psi.Perhaps "super power" was not the...

There are a lot of racer tricks that are not published when running times like that. You don't give out all of your secrets when trying to be competitive and running record breaking times. The L19s were thought of then, may have not been called that exactly, but better fastener technology was...

I don't think you are fully aware of the situation as you lead yourself to be.ARP head studs have failed at those pressures in the past, a lot. Why do you think the A1 head studs become popular? I can tell you it wasn't just marketing. You are fooling yourself if you really think those guys...

Is this something you are working on immediatly? Have you had any results?

I love this idea! I am by far from an electronics expert, but there must be a very simular way to do it in a newer infinity radio by using the tape deck input on the circut board. Can anyone elaborate further on this?

I thought it could have been a messed up rom/flash so I reflashed the stock rom back into it, reset everything and tried again with no luck. The CEL is annoying but I can deal with it.

Tephra v7 9653. Have you had any issue with the stationary rev limit?

Has anyone had any luck disabling the CAS codes with a USDM rom? Been having issues with the rev limiter on 9653 and trying to switch back to 9417. I copied the periphery data from the EDM rom but no success in stoping those codes.

Should be able to do 16-17 fine, but foolish to do it blindly.

FP68hta. Lucas is running 10s on it in race form. I'm sure you can easily run mid to high 7s in the 1/8 with it on pump and high 6s on race. What is your best 1/8mile to date?