+1 on the RTM drainI am running the RTM drain and in place of a restrictor I'm running a -3 line feed from the oil filter housing. The adapters were a PITA to sort out at first, but I used information from the site linked below. I've also linked the line that I ordered...
Looks like they were trying to make some reliefs for ARP turbo bolt washers to fit into. Not the greatest solution since the OEM washers fit the manifold just fine.
Based on your photos I don't think the cuts are deep enough to affect the manifold
Bringing this one back from the grave since I finally got a chance to check out the HX40W I bought over the winter.8 blade HX40W - came to me internally gated
18 cm^2 divided housing
Tag lists p/n 3587610
Cartridge is stamped with 3591758
Inducer: ~59.99mm
Exducer: ~80.41mmJust one item to...
I know this is super old at this point - but it ended up being that the balance shaft belt snapped and got wedged in the crank sensor. After repairing that issue it still wouldn't start and it was the replacement cam angle sensor I got from Autozone. Replaced it with one from Advance and it...
I wasn't able to take as many photos as I wanted to since I was carrying my dog most of the day lolLink to my Flikr album. I'll be updating it throughout the weekend.https://www.flickr.com/photos/mopardsm/sets/72157646434165046/
Just bought this car recently and the seller told me that it had problems starting but gave me a couple of methods to use to start it.One was to put the car in ACC and as soon as you heard the relay behind the radio click to rapidly switch the key to on. This worked when I tried it. The...