Helping a fellow DSMer out here in the Columbus, GA area out. He is asking $100 shipped. Shoot him a text if your interested.
GT4088R Dual ball bearing Open T4 housing 3" vband out Comp housing 4" inlet 2.5" out Low miles, spools fast. need to go bigger for my drag project. Good for 760 hp...
There are a few meets on Fridays and Saturdays in Columbus at the sonic and the parking garage. There are only a few DSM guys that I know of running around.
I live about 20 min outside of Columbus. I dont have any 1G parts but I do have a clean 96 FWD auto that I am parting out. The engine is not going but everything else will be up for grabs.
Well got enough stuff out of the way and found that it is an entire 1g 7bolt engine. Found the original owner had placed a couple nails through the top starter bolt hole and JB welded them in place. I pulled it out and cleaned the hole up and put a new starter bolt in to find that now the...
Ok new update. I ended up running a wire from the ignition harness B/R out to the starter signal plug under the hood. The car cranks. The first time I had to give it a shot of starter fluid, but after that she starts on her own. I havnt pulled the plugs yet but Im thinking they might be...
Ill have to check the MPI relay when I get back to the house. As far as I know its a 95 harness. I was told by the guy I bought it from just the head was swapped. The B/Y I checked under the hood was from the harness side. I will also check the starter solenoid side when I get home. I had...
From the relay harness the B/Y wire to the dashboard frame and door post the resistance is between .2 - .4 ohms. Under the hood on the harness side its like 23k ohms.Went out and double checked I guess I didn't make a good connection but now I am getting a steady 24k ohms at from the...
I have been searching through the forums and have yet to find the answer to my issue. The harness on mine was cut and rigged by the PO. I have 12.5v coming to my starter relay. I have determined that my starter relay is bad. When I jumper the B/R pin 4 to the B/Y pin 5 with the B/Y wire...
Just thought I would check in since I haven't been on in a while. The eclipse has been on hold for a couple months now due to my back completely going out on me. The second round of surgery was yesterday so hopefully within the next month or so I will be back out and about. Just a quick...
OK so I have come across a 1g 4 bolt LSD rear end wth axles and all mounting hardware to add to the list of parts I have for sale. The engine, transmission and intercooler are all gone now I still have The full AC system from my 2g turbo, along with the FWD axles. The drivers side has less...
I'm in EL Paso I have a 92 plymouth laser AWD with a spoiler could you send me a pic of the style your looking for and I can see if this one will work for you. You can text 845 667 6412 for a quicker response.