You actually were able to contact JayRacing in 2020? I'm astonished. I tried contacting JayRacing and never get any response whatsoever. I've read that others have tried with the same results.
Looks like a 100% ebay purchased parts build. Hell you can even see in the photos how the "rev9" manifold bolt holes aren't centered over the port. I've had 2 of these manifolds in my shop and they were both drilled wrong and had an offset partially blocking exhaust ports because of it...
Just pulled mine to do an inspection. I have a black cover [gvr4 oem]. It ate the ring. Nbd. Just run it. It will clearance itself. Haha. No issues here. I'm just confirming, yes a fluidampr will eat the extended ring on your timing cover if you don't trim it off.
My 70mm S90 whistles a little, but only at about 5% throttle. It's clearly not a boost leak. I suspect it's just the design of the inlet for the FIAV and IAC. Since i'm running an external IACS, this is all blocked off. I'm certain that the turbulence just before the throttle plate is causing...
I live in Monroe. Currently my car is torn apart for winter upgrades, though. I'll have it out in the spring.I've got quite a list of things i still need to get done before driving it again. I've had this magnus SMIM for far too long without putting it on. I just got BC inverted coilovers...
You might be able to drop the oilpan and all the caps, replace the bearings, and do a balance shaft elimination. If you've got a 6bolt to toss in there that is built, then by all means.. go nuts. Your 2g engine might still be good. Hell, i may even want it if he price is right and you want to...
Pacific Auto Machine in Renton is not the place to go, i can tell you that much.I hear Pina is a good place to deal with, but they're going to mark up machine shop rates, (they gotta get their cut, right?) AND you can't speak directly to the machinist if you go through them. This can be a...
Awesome info. I can't believe we didn't notice this and do something about it before. It's so dang simple!I'm getting my head and block back from the machine shop pretty soon. Before i assemble it, i intend to clearance this area out a bit as well.Thank you for bringing this to our...