Thanks all! I already have a full set of fluids including the requisite redline, so if the pumps are an effective method I think I'll go with that.

Anyone have any experience with using Amsoil in the transfer case? My understanding is that fills are a real pain so I'm hoping to try one that has a squeeze packet so I can just shove it in there.Alternatively, does anyone have any suggestions on any devices that I could pour T-case fluid in...

You should be able to just use stock lines, or upgrade to stainless. The fittings should be the same on the brembo end.

No, they aren't, they're just clear needles painted orange on the bottom. One of the lighting tutorials has someone that removed the paint then repainted with red.

You take paint thinner to the needles.

Well, the old car is a 2GB and the new one is a 2GA, I suppose I could check and see if there's any difference in the booster.

There seemed to have been a lot of discussion about different boosters and master cylinders. Is there any consensus as to which ones to use at this point?

Awesome, thanks. I may just do that then to make the swap easier.

What would happen if I were to install the appropriate brake booster for this upgrade early? I'm going to do an engine swap here shortly to get my new body up and running, so that would be the ideal time to get the new booster installed. However I don't really have the cash at the moment to...

Did you change your mind?

Technically I could probably make use of it as early as tomorrow, I have one of the engines almost ready to pull. However, I do need to get the OTHER motor ready to pull as well, which may not be ready to go until next weekend or so.I guess it depends on how long you're comfortable with me...

Fairwood/Cascade Center.

Does anyone local have an engine hoist I may be able to borrow? I'm getting pretty close to being able to swap the motor from my totaled Talon in to the new one I bought.

Bought my LEDs for my project, and they've arrived. Looking forward to getting them installed.For those of you that don't want to try to sand faces, I picked up a set of new gauge faces from Black Cat Custom Automotive - Gauge Faces for all makes and models of cars and trucks - LED Lighting...

YEP:1995 TSi AWD, has rod knock (probably a spun bearing).I'm going to pull out the 6-bolt and install the motor from my 97, and most likely return everything to more or less stock. Once I've sussed out the 6-bolt and rebuilt/repaired it, it'll likely go back in and I'll start...