Does anyone have consensus on what inner/outer toe rods are needed for each chassis?I’ve got a 2g with equal length inner and outer tie rods, tie rod ends are the longer set from what I can see in this thread and I have a greater steering angle to the drivers side than I do to the passenger...
I messaged the seller and confirmed that the gaskets can be sealed multiple times as long as they’re not damaged, although there isn’t currently a gasket set available he can sell extra gaskets and will be adding them to their website which is currently under construction.
So at literally half...
Any feedback from anyone that have been using this?Has anyone had to remove the cover after install, can the gasket be sealed multiple times, or do you need to order a replacement gasket kit from AER?
Agreed that it’s the same solution and I can’t tell you why when I went directly to the motor I didn’t see the same result but in ecstatic to have it working. Thank you for the guidance!!!
that second connector you show for the motor that’s just 2 pins where is that? When using only that 9 Pin connector that plugs in to the factory window/lock switch assembly the factory relay (I assumed there was one but wasn’t sure) definitely complicates the process as to go up You have to...
Hi, I’ve put aluminum door panels in my car and they came with 5 pin window switches.it seems that the factory wiring must use a relay somewhere as there are always 4 wires involved to make the window move.To go up you must jump Pin 8 to Pin 9 (which then causes Pin 6 to become hot) and...