I agree about him, but people like him just piss me off so bad.Even though I don't have any "proven results" I would recommend this manifold. In my opinion it is actually a quality build. It has everything I think a smim should, being the velocity stacks, equal runner etc. one thing I did...
Just to shut you the #### up if/when I get it going again I will take it to the track with the stock mani, run it, then put this one on and run again. I'm not going to dyno it though because dynos don't mean a damn thing to me personally, therefore my car will likely never see on unless I decide...
Urban why don't you gtfo if your just going to talk shit. God forbid after all the money I've spent on name brand parts I want to try an eBay manifold that I even said I bought for looks over all if it performs it will be a plus and from actually inspecting it on my hands I don't see why it...
Easy was easy and very straight forward like any other intake mani with the exception of it the throttle body sitting a little lower and the angle is a little different but still fit fine with my pr fmic pipes. I didn't straight edge the flanges but it doesn't leak with a standard fel pro gasket...
Ok tomorrow I will. It's just weird as soon as it hits around 3k it falls on its face and is lean then if I wot it will slowly richen up and start to pull again. Check back tomorrow evening if you have time and ill try to have a log up.I'm also going to run a ground from the battery in my...
False alarm problem is still there, but I've found that when it leans out if I go wot it will start to richen back up. I'm at a loss injectors checked out good, fuel flow seems good. Anyone have anymore ideas? Could this be a problem with the Cas or anything else somehow?I'm so close to...
They did it just didn't make any sense to me it listed the injectors down the side then up top it said 600 2500 5000 under the 600 the all said 21-23cc and under the 2500 they all said 74-76cc so I'm just confused at what tha t mean exactly. I'm going to try to fix the tune in a couple hours so...
Ok update time. I found a local place to clean and flow test my injectors. Took them down there and a day and $45 later I had them back. I've been working so much I haven't had time to mess with it. I got a few free minutes just now and popped the injectors back in. Didn't have time to mess with...
Thank you very much. I'll let you all know how it goes this afternoon.Ok so I just turned the injectors off 1 by 1 and all of them you can really tell a difference except cylinder 2. when I turn it off the idle will stay pretty much the same, not a drastic difference like the rest, but my...
Yea I was on my phone so it just shot to top of the page. I used my laptop and it took me to the post I've been reading through it lol.
So if I pop that map in should I focus on using the global to get the afr as close to 14.7 as possible then use the ve to get the airflow around .25? Which...
Yea this rebuild I did everything except the rotating assembly, could be the reason I am having so many problems lmao. Also I didn't name drop to gofer but I may have also gave him a link to the thread, but maybe we will get lucky and he won't read all the posts lol.Edit reply: could you...