Dye is great! That's how I discovered a cracked transmission case once... Also, it does really help to start with a clean trans/engine before doing such a test.
^tunedbysaturnsl basically covered it. I also replaced the master and booster with 3G parts (over a year ago) and the booster BARELY fits. I had to pass it under the intake manifold from the battery side of the engine bay with some amount of cussing to get it over to the drivers side. Also...
Just to confirm, this is a 4g63 platform and not a 420a you're working on correct? I ask because I have a 99 GS in addition to my GSX, and the 420a blocks have a bed plate design. Upon rebuilding my 420a several years ago (broken timing belt) upon first assembly and startup in the car I had a...
So, here's a long overdue update. I finally got around to devoting some time to this again recently and have gotten the car running well (aside from a small problem called out below). I had 2 issues preventing the car from starting, an intermittent connection issue with the CAS signal wire that...
Hey guys,
I'm performing a small garage clean out. The following parts are just what I have put into a list at this time.
If there are other items you need feel free to ask if I have it, though most of what I have are used OEM parts. Prices don't include shipping, however prices can be flexible...
Are you referring to 1 belt or 2? Aren't the alternator and PS belts separate? I'm also running a 6bolt swapped 2G but my alternator is relocated to the AC compressor location. I can vaguely remember the stock belt configuration at this point? If a belt will not tighten and there's nothing...
Thanks for posting an update Critic. I've either been out of town or sick in the last week and haven't done anything with my car since. I still have a bit to do before I'm ready to try and start the car up again. Although I'm kind of expecting the same result you got...
Awesome. Thanks for the info and screenshots twicks. I will try to compare with my settings this afternoon. Do you think phasing issues could prevent the car from synchronizing for startup? Or would it only prevent it from firing and running? In my case I've noticed that "Stat Sync'd" does not...
I see. I would turn off your injectors (if you haven't already) until you know your ECU is going to sync properly. What CAS are you running? One thought I've had all this time is that something may be different from trying to run the 2G hall effect (what I'm trying to run) versus the 1G optical...
Hey Kevin, I figured I would post a small update here so this is all documented.I did test and confirm that I'm getting 5V on the CAS signal wire when the sensor is unplugged. I expected this to be the case because the car runs fine with this same signal wire on the 1G CAS setup. I also...