Just wanted to double check if the timing marks are correct, Or is it off a tooth?

During the process of removing the dowel pin , I Slightly nick the surface of the block . Will I be ok using a composite gasket?

Is this correct?

I'm trying to run my aem 3.5 map sensor to log boost with a stock 2g maf . Is that possible? I hooked everything and the aem map sensor is reading -27.7.

I'm running a evo 3 intake manifold , the map sensor is to T- the brake booster . I wired the aem senor with the mpd connector wires. When I took it for a drive the map sensor value stays at -27.7. Log posted below.

Can I use a turn signal switch from a 99 eclipse ? The amazon link says it will fit for a 99 gsx but not a 95 talon tsi.https://www.amazon.com/Standard-Motor-Products-CBS-1096-Signal/dp/B000EQFOQA?keywords=turn+signal+switch+eclipse&qid=1528998231&sr=8-7&ref=mp_s_a_1_7

I recently took out my dash to replace my heater core.I forgot to take pictures of where my climate control cable goes to.

Is this the correct part for the 2g talon heater core?https://www.rockauto.com/en/moreinfo.php?pk=946911&cc=1433929&jsn=341...

Is this correct?

Thanks!!^^

I’m replacing the TPS sensor connector and got one on eBay and there are different colors from the factory wires . Where does the other 2 green wire match up too.

Do they sell the gasket for the lower timing belt cover or can I use black rtv?

I just replace the balance shaft sprocket , and yes it’s a 2g 7 bolt.

Is this the correct way the bs belt goes , when I align it on the outer groves it rubs against the plate.

After doing a compression test 60-120-155-155 , I took out the head and found this on piston #4. It’s looks like it’s been melted. Does the block needs a new rebuild?