These were inside my fog lights. First photo.
After they were removed and new two color LEDS were installed the fog lights it looked like the second photo with lenses removed.
Don’t know if this helps, but I installed two color leds in my MES 1999 Gs. The bulb housing was to long for the fog light housing , but the backs unscrew. Which I believe helps with cooling. A slot is needed to thread the wire through. Thanks dremel type tool. Flash lights to brights and fogs...
My local Mitsubishi dealer got them for me at $3 and some change.
My question:
Has anyone tried to use a bronze flange or heave wall sleeve bushing as an alternative ??
Amazon has bunting bearings ECOP050808
Or Bunt flange bearing EXEF050706
That should work. ????
Additional details
Add several washers or a nut to the socket to keep it from touching the base, a pipe wrench on the impact driver adds extra torque. Not much pressure is needed the hammer takes a lot of stress off the threads ! A must have for working on old stuff. !
Mine is 50+ years old...