I think my fix was I rewired everything nicely thicker wires, new connector, more grounds and i believe that was what fixed the issue. It is warm but not burning hot like before.
For sale I have Galant 90amp alt (60), Saturn 140amp 1wire (80), 2g transistor (20), fp turbo oil feed filter (15), ignition wires ACCEL (30), ignition coil (20), reverse backup camera universal brand new (20). Prices are in ()! Message me, need these items gone asap! Thanks!
hmm the battery light does not come on at all, or maybe when key on, don't recall, but when key on all lights go on as normal, when car on no lights are on. But with Saturn alternator, I thought since it is a 1 wire it eliminates all other stock harness wires. I just have a 0 gauge straight to a...
Hmm I checked the engine light just now and it turns on then off after about 5 sec, normal operation. I had a bad d103 cap in ECU and Tom fixed and inspected ECU, tested working, before I wasn't able to log on dsmlink, now that I put in the new ECU I can log and everything seems to be working...
Hey guys, I have been having this issue since hurricane Irma passed by here in FL. Car was sitting outside, not sure if maybe the wind or rain could of caused anything, although no flooding or any damage happened at all to the vehicle or the area nearby.But anywho, before hurricane car was...
Well I'm running the STM rewire kit:http://www.streettunedmotorsports.com/parts/stm_fuel_pump_rewire_kit.htmI believe they use a 10gauge or 12 gauge for that blue power wire. I replaced the thinner blue wire from that connector and used the thicker gauge blue power wire as one full wire...
Hmm a little confused here. Can you be more specific on instructions here? If it still heats up it means bad pump?Also I removed spade connectors as well and I soldered still heating up.
how exactly would you measure votage drop from one wire? I replaced the ground from relay and put it on a strong chassis with no paint in the trunk. Same ground I'm using for negative on battery. It still heats up. I then replaced all connectors and ran them as one wire, the red and the black...
Hey guys, have an issue. I did the rewire as this guide for 2g AWD:Now I eliminated stock connectors and am running a bulkhead fitting with the 5 wires connected directly. Before the rewire everything was perfect no heating of wiring or anything. After rewire, we rewired like diagram wired...
Hey guys, been having this issue for quite a while and can't seem to solve it. On a very cold start, the car starts up nicely, sometimes. Other times it is hard start and when it does start, it idles rough for a few seconds and dies. I restart it and same thing, it keeps dying and dying. I rev...
Hmm, well since I thought alternator was good, I reinstalled alternator and it ran good for 20 minutes, I check voltage at alternator and it 14.5, at distribution block it was 13.1, and battery at 11.75, this was after 20 minutes of idle. In the beginning when warming up, alternator was at 15...
Hey everyone, been having an issue with the car, like always.. Car was fine, then out of no where while driving on the highway, the car stumbles and CEL comes on for a second, then car goes normal again. This happened a few times and I noticed battery voltage real low (have battery voltage set...
Yea mine not recirculated and never had this problem. Mine still holds up and has been on since they first out. I DD with 27psi of boost. I know locals with this BOV and they are good. Buy an o-ring for that and fix it.