The fitment and tension on the pipes matters also. I had to cut and weld mine to fit correctly.

The line that goes to whatever solenoid that is.

I typed it then backed off because I think the main issue is the pump just from the noise.

The two sensors in a 2G share the same power and (practically the same) ground deeper in the harness. The third wire in each connector is the signal wire.When using a 1G CAS, there is one connector with four wires: the power, the ground...

I’d put a new Walbro in it and fix/change that wiring. The whine is generally a sign but then again if voltages go crazy I’ve seen the same.

OBO

That’s an alignment issue. Everything that needs to be tight should. Everything that needs to move freely should. Tires. Alignment. Set for tens of thousands of miles.

Justin is correct. Too much camber will not wear the edges (well maybe after 500,000 miles I suppose). Your inside edge tire wear problem is too much toe out.

I’m thinking someone is going to have to 3D print them. The Rix racing one is only for 6 bolt in a 2G I believe.

There’s a learning curve with everything. The main thing is to check everything over and get it tuned. I second the cams are too big for the 68HTA. I wouldn’t put anything past 272’s with mine because the power band wouldn’t make sense any...

🍿

How does spraying fuel in your exhaust help your cylinder temperatures? That’s right. It doesn’t.I have been 230mph in a dsm at Bonneville with no intercooler. We road raced a 500whp Galant for YEARS with no intercooler. I made 800whp with my...

I have a couple

I’m stripping this down and scrapping it. Just let me know. I should have them.

I have a couple spares that I’d like to clean up and sell or just have for spares. Without installing and having crank pressure show me a crack, is there any way to verify before putting in the effort to clean them up? I understand they usually...

We've been slowly chipping away at finding quality solutions to Mitsubishi's ever-increasing pricing updates, and lack of availability. It was great being able to get a quality timing kit from Mitsu back in the 90's and just move forward with...